Pajero anti-roll bar bushes replacement MK 2
Steps
- loosen and remove first top nut on anti-roll bar ( arb )
- loosen and remove second nut on arb
- remove the washers and top rubber noting the order
- loosen bottom nut that bolts to the lower a-arm
- jack up arb with a bottle jack until the arb clears the shaft
- swivel the shaft out and replace the bottom rubber - I actually removed the whole thing
- swivel back the shaft and slowly release the arb back onto the threaded area
- put other stuff back in order - noting to compress the rubbers for about 5 turns only ( if you keep turning the first nut you will over compress the rubbers and make them fail early ) and then doing the up the second nut tightly.
- clean up
Tools required
14mm spanner
14mm socket and ratchet
4 poly replacements
Time
My first time took 25 minutes in total for both sides including packing tools away